How to prepare a porous surface for gilding

About to gild raw wood, plaster or cardboard? Even before the leaf, there is a step that makes all the difference. On porous surfaces it is important to reduce and even out absorption before moving on to the next stages of preparation.

Prep & Seal is the first step on these surfaces: a water-based gel pore sealer whose ultra-thin, transparent film reduces porosity and evens out absorption, creating a consistent base for the work that follows. In this tutorial we show you how to apply it, from preparing the surface to achieving a smooth, even base.

You will need: Prep & Seal, fine-grit abrasive paper and a brush.

Procedure

  1. Sand the surface with fine-grit abrasive paper and carefully remove the dust.
  2. Mix the product thoroughly before use.
  3. With the brush, apply 1–2 even coats, without excess product.
  4. Leave to dry: 6–8 hours in total after application, the surface is completely dry and ready for the next stages of gilding.

Tips

  • If the moisture in the product raises the wood fibres, sand again with very fine abrasive paper or steel wool.

Follow the video tutorial and let it guide you step by step. Is your surface ready? Share your progress on Instagram, tagging @giustomanettibattiloro: we can’t wait to see where your project takes you!

Made in Italy craftsmanship

Made in Italy craftsmanship

Certified and responsibly sourced gold

Certified and responsibly sourced gold

Worldwide shipping

Worldwide shipping

Customer support

Customer support

10% OFF
✨Subscribe to our newsletter and get an instant discount on your first purchase in our online shop!✨
10% OFF
10% OFF
✨Subscribe to our newsletter and get an instant discount on your first purchase in our online shop!✨